An ultrafine-grained (UFG) ZK60Mg alloy with an average grain size of∼ 1.0 μm was processed by extrusion at relatively low temperature (488K) with a high area reduction ratio …
HJ Choi, Y Kim, JH Shin, DH Bae - Materials Science and Engineering: A, 2010 - Elsevier
This study investigates the deformation behavior of magnesium produced by hot extrusion of ball-milled powders in grains ranging from 120μm down to 60nm in size. For microcrystalline …
The effect of Y concentration on the slip and twinning mechanisms in binary Mg–Y alloys are investigated using transmission electron microscopy, electron backscattered diffraction, and …
The effect of strain rate, ε̇, and temperature, T, on the tension–compression asymmetry (TCA) in a dilute and wrought Mg alloy, AM30, over a temperature range that covers both …
Tensile twinning is a key deformation mode in magnesium and its alloys, as well as in other hcp metals. However, the fundamentals of this mechanism are still not fully understood. In …
We review the dynamic behavior of magnesium alloys through a survey of the literature and a comparison with our own high-strain-rate experiments. We describe high-strain-rate …
BY Liu, Z Zhang, F Liu, N Yang, B Li, P Chen… - Nature …, 2022 - nature.com
Magnesium, the lightest structural metal, usually exhibits limited ambient plasticity when compressed along its crystallographic c-axis (the “hard” orientation of magnesium). Here we …
H Miura*, X Yang, T Sakai, H Nogawa… - Philosophical …, 2005 - Taylor & Francis
The high temperature deformation behavior of Mg single crystals was precisely investigated using orientation imaging microscopy. For this purpose, Mg single crystals of various …
X Luo, Z Feng, T Yu, J Luo, T Huang, G Wu, N Hansen… - Acta Materialia, 2020 - Elsevier
Abstract Samples of Mg-3Gd (wt.%) were prepared by accumulative roll-bonding followed by annealing at different temperatures to produce samples with average grain sizes ranging …