… ” II and III of single-crystal hardening in fcc metals. … strain hardening was not included.
Mecking and Kocks concentrated on the parallels between single-crystal and polycrystal hardening…

… pure strain hardening. A third part shows that, even starting from a rate dependent assumption
for the single crystal plastic flow, the present analysis of latent hardening … for fcc crystals to …

… This stage of hardening, termed Stage III, and being characterizable by a strain hardening
… We have discussed specific mechanisms for strain hardening and recovery in both the cell …

… Finally, simulations of the deformation of [loo] crystals are reported and the results are
discussed in terms of the possible dislocation mechanisms leading to strain hardening. …

… of a cyclic strain hardening curve for annealed fcc metals is … first cycle the crystal extends
and any strain hardening which … with hardening in the unidirectional deformation of fcc metals…

… coefficient θ4 at the fourth stage for metals with a face-centered cubic (fcc) lattice is approximately
equal to 0.05θ2, where θ2 is the strainhardening coefficient at the second stage. At the …

… strains to which the crystals were ultimately subjected, and the comparatively large diameter
of the crystals. … of the electrolyticall;y etched surface of a crystal revealed a “micro-mosaic,” …

… and latent hardening in Fe crystals by KEH (1965) and NAKADA and KEH (1966). To … -loaded
cubic crystals in single slip, we direct attention here to fcc crystals in the compression test. …

… Figure 2 shows the strain hardening behaviour for single crystals of Cu,Au in both the
ordered and disordered condition. The disordered crystals have initially a zero strain hardening …

… , the strain hardening curves of some fcc and bcc metallic crystals … concerning the influence
of crystal microstructure on the … of dislocations in fcc metals changes approximately linearly …