The aim of the paper was to present issues related to the determination of the influence of
selected technological factors: the method of surface preparation and type of adhesive on …

The aim of the article was to present issues related to the determination of the impact of
selected technological factors: the method of surface treatment and the type of adhesive on …

The aim of the article was to present issues related to the determination of the influence of
the surface preparation method on the strength of adhesive joints made of three types of …

The paper analyzed the shear strength of the single-lap adhesive joints made of zinc
galvanized coat of steel sheet. Mechanical treatment of the samples was carried out using …

The presented study concerned the comparison of the adhesive joints strengths of 1.0503
carbon steel sheets of higher quality, which were made using adhesive compounds …

The aim of this study was to determine the effect of abrasive treatment as a method of
surface preparation on the strength of adhesive joints made of galvanised steel sheet. The …

The article compared the strength results of single-lap adhesive joints made of galvanized
steel sheet. The strength of adhesive joints was determined for two methods of surface …

The aim of experimental studies was to determine the influence of surface treatment on the
adhesive joints strength of steel sheets. In a study accepted one of the possible methods of …

The following paper analyses selected problems regarding the impact of technological
parameters and the type of adherend material on the strength of adhesive-bonded steel …

The paper evaluates the effect of the surface treatment on the strength of the single-lap
adhesive joints made of the C45 steel. The samples were joined using an adhesive …