… 0.2, 0.5, 1.0 wt%) were studied at room temperature. Ce additions to ternary Mg-Sn-Ca alloy
… of second phase from CaMgSn to (Ca, Ce)MgSn and Mg 12 Ce. The volume fraction of …

… master alloy were used to prepare the Mg–6Al–1Ca (wt%) alloy. The raw materials were …
and a cross-section of 1.0 × 1.0 mm 2 had been extracted from the Mg–6Al–1Ca extruded bar, …

… Sn-0.5Zn-0.5Ca (all in wt%) alloy sheets were investigated … that the Mg-1.0Sn and Mg-1.0Sn-0.5Zn
alloys exhibited … the Mg-1.0Sn-0.7Ca and Mg-1.0Sn-0.5Zn-0.5Ca alloys showed …

… under a mixture of SF 6 and CO 2 gas atmosphere and cast different Mg-Ca alloy with Ca
content of 1.0, 2.0, and 3.0 wt.% [17]. It has been reported that the microstructure of all the cast …

… For example, Mg-8.2Gd-3.8Y-1.0Zn-0.4Zr (all compositions are expressed in weight % in
this paper unless otherwise specified) produced by extrusion, large-strain hot rolling and …

… Ca and Sr, are a current research frontier. In this study, biodegradable ultrafine-grained pure
Mg, Mg–Ca alloy, and Mg–Sr alloy … The grain size of the as-cast pure Mg was 1.0 ± 0.8 mm …

… Mg 2 Ca phase in the tested alloy [12]. Also, Aghion et al. supported the beneficial effect of
0.4 wt% Ca addition on Mg–Nd–Y–Zr alloy … characterize a Mg–Ca alloy at low Ca percentage (…

… Mg addition content was approximately 1.0 wt% in Zn-Mg … Zn-0.6Mg alloy with Ca addition
than that of Zn-0.6Mg alloy through … properties of Zn-Mg-Ca alloy, the microstructural evolution, …

… Mg‒Zn‒Ca alloys (Mg-3.2Zn-1.6Ca at 150C, 175C, 200C and 225C; Mg-1.05Zn-0.5Ca and
Mg-1.9Zn-0.3Ca … Ca 2 Mg 6 Zn 3 , while the precipitation of Mg 2 Ca had no or little effect (in …

… , ~0.6 wt% and ~1.0 wt%, were added into the Mg-1.0 wt% Ca based alloys, to clarify their
effects on modifying the microstructure and mechanical properties of as-extruded Mg samples. …