… Again the variation in MRR using present model is similar to the experimental results. As …
model and the experimental values are due to the assumptions taken in the present analysis. …

… , for example, the material removal of ductile materials is … on the material surface [21, 22],
the material removal of brittle … FE model of type I were compared with the experimental craters …

… A comparative study of existing literature data of MRR of quartz material and experimental
data with the FEA analysis shown in the Fig. 11. It is clearly observed that the FEA …

… FE models of the slide diamond burnishing (SDB) process … experimental approach is
numerical simulation via the finite … of the specimen are reduced via material removal [74]. Hence, …

… and cutting parameters for surface finish and Material Removal Rate (MRR) using … the finite
element model with the experiments is less than 2%. This means that the developed model …

… In this work, finite element method is used to simulate turning of … DEFORM 3D software is
used for finite element analysis. … Experimental data of material removal rate and tool wear are …

… nonconductive materials machined with this process are … , a Finite Element Model (FEM) of
the ECDM process is carried … the Material Removal Rate (MRR) as a process output response …

… material removal during discharge. Marafona and Chousal [20] proposed a thermo-electrical
model based on finite element method … our model and Salonitis model and experimental …

… Finally, a closer proximity to experimental material removal rates … A comparative analysis
is needed to unveil the effect of different values of F c on the predictive accuracy of our FE model…

… model and 3D finite element model were developed by Yildiz [Citation22] for the prediction
of material removal rate … Table 4 shows the experimental results of the material removal rate (…