In the system CaO−P₂O₅−H₂O 13 different solids with varying Ca/P ratios are known. In addition calcium phosphates containing other biocompatible constituents like Na, or K, or Mg or Cl or carbonate, are known. Therefore, a large number of combinations of such compounds is possible which might result in the formation of calcium phosphate cements upon mixing with water. However, the number of calcium phosphates possibly formed by precipitation at room or body temperatures is limited to 12, which should limit the number of suitable combinations. In this study more than 450 different combinations of reactants have been investigated. The results were evaluated on the basis of the following criteria: (a) was the intended reaction product formed? (b) was the final setting time shorter than 60 min? (c) was the compressive strength after soaking for 1 day in Ringer's solution at 37°C higher than 2 MPa? We found that 15 formulations satisfied all of these criteria. The distribution of cements synthesized in this way was 3 DCPD type, 3 CMP type, 6 OCP type and 3 CDHA type cements. The DCPD type cements were acidic during setting and remained that for a long time afterwards. CDHA type cements were neutral or basic during setting, and remained neutral after completion of the reaction. The OCP type cements were neutral both during and after setting. Two CMP type cements were basic both during and after setting. In this study compressive strengths were found up to 90 MPa. Also, in the literature values up to 90 MPa have been reported for this type of cement. Taking into account the excellent biocompatibility and the good osteoconductivity of calcium phosphates and the fact that these calcium phosphate cements can be injected into the site of operation, it may be expected that these materials will become the materials of choice for bone replacement and augmentation. Their suitability for the fixation of metal endoprostheses for joint replacement should be investigated as well.