The aim of this study is to improve the tribological behaviour of aluminium alloys by using grain refiner and modifier. The effects of Al5Ti1B grain refiner and Al10Sr modifier additives on friction and wear properties on A380, A357 alloys produced by pouring sand andpermanent mould casting were investigated. Abrasion tests were carried out under dry conditions against St1040 steel disc using a pin-disk system with 20 N load and 1.0 m/s sliding speed. It was determined that grain refiner and modifier additives decrease the friction coefficient and increase the wear resistance. It was determined that the samples produced by permanent mould casting method decreased the friction resistance by 9% and the abrasion resistance increased by 40% compared to the samples produced in sand mould. The lowest wear rate was obtained in A380 alloy with TiB and Sr added with a value of 4.87 × 10^–11 m²/N.