… over energy input and localised hardening etc. This work presents the effect of different laser
parameters on the micro hardness of SS316L after laser hardening. The experimental work …

… decreasing with increasing laser power between 165 and 285 W by tuning other parameters.
In this study, the lowest porosity (<0.03%) achieved for SS316L was at a laser power of 285 …

… the surface of SS 316L fabricated through the DMLS process. The effect of shot peening
has been reported with special reference to surface roughness, surface hardness, surface …

… The primary objective of this review is to provide a comprehensive overview of recent advances
in modeling the laser surface hardening. It will cover the latest developments in thermal, …

… focused on the laser texturing of Ti-6Al-4V titanium alloy and SS316L stainless steel alloy …
fiber laser processing system. Laser texturing parameters involving different surface laser …

… has been reported on SS316L wall surfaces cut using a continuous-wave CO 2 laser [29]. …
J / c m 2 ) is far greater than the ablation threshold fluence of SS316L, ie, 0.45 ± 0.13 J / c m 2 . …

… a high-powered laser to form near-fully dense 3D components. The SS316L is an austenitic
… and angle orientation on hardness of the SS316L specimen fabricated through SLM. It has …

… the surface hardness and tensile strength decreased owing to microstructural evolution. During
the pin-on-disk test, the conventional SS316L … process of SS316L in terms of laser power, …

… laser irradiations similar to an in-process annealing. Furthermore, the top surface hardness
is higher than the lateral surface hardness due to … laser shots; in contrast to the top surface …

… This surface impact improves the ability of the surface to resist biofouling and corrosion [12, …
-step laser texturing of the SS316L material will be carried out by varying the laser output …