In recent times, the thermochemical energy storage (TCES) method is gaining prominence due to its high energy storage density and minimal heat losses compared to the conventional thermal energy storage (TES) methods. This paper presents the cyclability behavior of selected zeolites for the TCES applications. The zeolites were subjected to sequential desorption and adsorption processes for five times using a differential thermogravimetric analyzer (DTG-60H). To investigate their suitability for the commonly available sources of thermal energy (e.g. solar energy, industrial waste heat), the samples were heated up to 150°C. These zeolites were also tested on Brunauer–Emmet–Teller (BET) analyzer for total surface areas and pore volumes, thus to read their sorption behavior. A field emission scanning electron microscope (FESEM) equipped with an energy dispersive X-ray (EDX) analyzer was used to examine the surface morphology and elemental composition of zeolite sorbents before and after the multi-cycle test run. The changes in the mass of a material during a process, either desorption or adsorption, were notably almost the same across the cycles tested, which confirms the cyclability of the materials tested. Amongst the tested materials, Zeolite-NaY and Zeolite-HY exhibited relatively better process enthalpies owing to their active water adsorption capacities. Of the six materials tested, Zeolite-NaY has offered better results and its enthalpies range from 287.5 J g⁻¹ to 348.5 J g⁻¹ for the desorption and from 81 J g⁻¹ to 292.1 J g⁻¹ for the adsorption. A mass gain was noticed for each of the tested materials as they undergo the cooling process, thus affecting water vapor adsorption capacity negatively.