… response to ionisation as a function of momentum and incident angle. … To measure the
resolution of the track parameters the cosmic-ray tracks which traverse the ATLAS detector from …

… The dependence of the current from the Total Ionising Dose (TID) and temperature has been
… the measurement results and gives a parameterisation of the leakage current and detector …

… particles with the ATLAS detector at the LHC using an integrated luminosity of 139 fb …
measurement assigned to each track is then calculated by averaging the ionisation measurements (…

… a specific ionisation higher than any high-momentum Standard Model particle of unit charge.
The pixel subsystem of the ATLAS detector is used in this search to measure the ionisation …

… the read-out of the calorimeter cells that can be used to distinguish ionisation signals from
noise. The measured pulse is compared with the expectation from simulation of the electronics …

… a measurement of bunch-by-bunch luminosities in ATLAS by … The ionisation charge however
is reduced by charge … the BCM detector modules and included it in the full ATLAS detector …

… errors to the track-position measurement in one tube (eg … The ATLAS detector will be a
general-purpose proton-proton … the pulse, such measuring the drift time of the ionisation electrons. …

… The measurement presented in this thesis has been performed using the full 2011 ATLAS
… in this thesis has been collected with the ATLAS detector in 7 TeV proton-proton collisions at …

… a specific ionisation higher than any high-momentum Standard Model particle of unit charge.
The pixel subsystem of the ATLAS detector is used in this search to measure the ionisation …

… upgrade of the ATLAS detector, the current Inner Detector (ID… dose at end-of-life with a high
rate, low rate of ionising … Middle: noise level of the modules measured warm and cold with …