… and corner efficiency factor. Then the corners are modeled in Abaqus using CDP and results
of … An extra scientific problem described in this paper is a proper choice of CDP parameters. …

… with the same and with different section heights of elements joining in corner. FEM analyses
in Abaqus were performed using CDP model. Efficiency factors of corners were established …

… In short, providing too large reinforcement in RC frame corners … • CDP model is able to
reproduce crack width of reinforced concrete structure. In the analyzed case of RC frame corners …

… The secondary, but also important issue of the research was to calibrate some important
CDP model parameters. The main motivation to perform all these analyses was to supplement …

… section height (dapped beam, frame corner), an opening (beam… Authors of the paper performed
calculations of RC frame corner … The yield function in CDP model is defined according to …

… Szczecina M., Winnicki A., “FEM and Strut-and-Tie analysis of RC frame corners under opening
… Szczecina M., Winnicki A., “Numerical models and analyses of RC frame corners under …

… The secondary, but also important issue of the research was to calibrate some important
CDP model parameters. The main motivation to perform all these analyses was to supplement …

… is checked on the example ofreinforced concrete frame corners under opening bending …
some aspects concerning CDP model implemented in Abaqus [1] software. This model was …

… The CDP model [18] is an isotropic model that uses concepts of damaged elasticity in …
material models exhibiting softening behaviour and stiffness degradation, the CDP model allows to …

… [1] and present some results for frame corners under opening bending moment. Moreover,
to … FEM calculations were performed in Abaqus using CDP model for concrete. In this model …