… this method… removal on its own level by increasing the time of the reaction time [Citation24].
The interaction of two parameters (dye concentration and ultrasound time) to the dye removal …

… Experiments were performed according to the central composite design (CCD) matrix
given in Table 3. The response was expressed as percent dye removal, calculated as ((C 0 …

… A 2 4 full factorial central composite design was successfully employed for experimental
design and analysis of the results. The combined effect of pH, temperature, particle size and …

… of 8.0 on the simultaneous adsorption of the two dyes on the SnS-AC. Analysis of variance
(… dye removal by SnS-AC with more than 95% over a very short time (12 mg L −1 of each dye, …

… The main design strategies that are applied to physicochemical removal of dyes are full
factorial design (FFD), central composite design (CCD), Box-Behnken design (BBD), and …

… design implementing response surface methodology was … sludge generation and removal
of pollutants from dye-based … CTSS) removal, chemical oxygen demand (COD) removal and …

… A 2 4 full factorial central composite design was successfully employed for experimental
design and analysis of the results. The combined effect of pH, temperature, particle size and …

… The adsorptive removal of Methylene Blue (MB) dye using a … Response Surface Methodology
has been employed to … , removal of MB and recovery of adsorbed dye using Design Expert …

… A wide range of dyes are being disposed in water … the removal process of dyes. It is important
to understand the stochastic and highly redundant behavior of the process of dye removal (…

… /model disperse dye removal by adsorption … and dye concentration, and optimal conditions
for colour removal were determined. In the second step, the experimental results of the design …