… treatments has been carried out, analysing the influence of the nature of the aluminium alloys
and the epoxy adhesives … After surface treatment, aluminium pieces (100×25×1.4 mm 3 ) …

… the epoxy adhesive although the final conversion is still high. The contact angle of nanoreinforced
adhesives on the surface of treated … on the surface treatment applied to the laminates. …

… , but it not only requires a careful surface preparation of the adherends but also is … surface
treatments such as plasma surface treatment, mechanical abrasion, and sandblast treatment …

… treatments has been studied through surface … adhesives in association with different
surface treatments allows drawing some conclusions on the role and potential interest of surface …

… the effect of surface treatment by sandpaper rubbing on the strength of adhesive joints. In
the … A two-component epoxy adhesive Araldite 2015 was used to bond the joints in a mixing …

… the lap shear strength of adhesive joints in carbon fibre/epoxy laminates. The effect of the
surface treatment of these substrates and the reinforcement of the epoxy adhesive with carbon …

… , rough substrate surfaces can enlarge the adhesive bonding … of epoxy adhesive is ensured
[11]. The resin pre-coating (RPC) method is a simple way of sealing surface and sub-surface …

… of the RPC surface treatment method on the bonding property of epoxy joints between …
treatment were prepared. The shear strength, failure mode, adherend failure ratio and surface …

… epoxies adhesives are mainly used due to their good mechanical, thermal and chemical
properties [1]. The epoxy … of the adhesive, it can be concluded that the surface treatment will not …

… for CFRP composite materials bonded with an epoxy adhesive. The effect of this treatment
on the surface chemistry and morphology of the composite laminates and on the failure …