… Figure 2 shows SEM micrographs of as-cast Mg–3Zn, Mg–6Zn alloys and T4 heat treated …
The microstructure of the T4 heat treated Mg–3Zn alloys shows no significant change (Fig. 2b). …

The effects of two kinds of heat treatments T4 (solution treatment) and T6 (aging treatment)
on the corrosion behaviors of Mg-3Zn magnesium alloy were studied by electrochemical …

… time heat treatment, I-phase transforms to the cubic W-Mg 3 Zn 3 Y 2 phase (bright particles).
Its composition is analyzed to lie inside the range from Mg 23.6 Zn 54.1 Y 22.3 to Mg 28.3 …

… In this study, the influence of homogenisation heat treatment effect on Zn–3Mg alloy
proposed for … Effects of heat treatment on corrosion behaviors of Mg–3Zn magnesium alloy …

… of Mg-5Zn alloy. The Zn-rich phases dissolved by the T4 treatment and only the T4-treated
Mg-… The polarization resistance (R p ) of the T4-treated Mg-1, 3, and 5Zn alloys was 2 to 10 …

… to Mg–Y alloys influences microstructure considerably. Quasicrystalline I-phase (Mg 3 Zn 6
… in the as cast state or after a heat treatment in alloys with a relatively low Zn concentration (…

… In this study, the degradation behaviour and mechanical properties of the heat-treated Mg-2Zn-0.2Mn-xNd
(MZM-xNd) in the simulated body fluid were analyzed using XRD, XPS, FT-IR, …

… Mg 95.5 Y 3 Zn 1.5 alloy was hot extruded at the temperature of 450 C before undergoing
the following heat treatments… typical recrystallization temperatures for magnesium alloys (about …

… Zn ratio increases both after 8 hours heat treated and 16 hours heat treated samples. It can
be suggested that in the galvanic couple of Mg3Zn, α-Mg matrix phase behaves as an anode …

… of Mg-2Zn and Mg-3Zn, respectively. Indeed, the Zn segregations of Mg-0.5Zn in this work
disappear after heat treatment at 400 C, whereas the corrosion performance deteriorates. …