… a fully nano-lamella structure was achieved by SLM. Such a nano-lamellar structure leads to
an … -lamella structure in this study enable an excellent combination of strength and ductility. …

… The results showed that the lamellar structure was composed of … of the lamellar structure
increased, and the lamellar length … lamellar structure to a short lamellar and an equiaxed …

… 2.1 EHEAs, underscoring the ability of additive manufacturing to produce highly metastable
… mechanical behaviour of highly aligned lamellar structures produced by other routes such as …

… , are derived from variations in the microfiber lamellar angle of this plywood motif, and are
… the structure-based variations in mechanical performance of a simplified cylindrical lamellar …

… in the lamellar zone. The lamellar structure in the melt pool observed in this study is a
typical microstructure observed in eutectic alloys. However, the formation of a lamellar eutectic …

… 3, the additive manufacturing of the precursor in this work is achieved by repeating two
steps: 1) the supplementation of a slurry layer consisting of ceramic powders and resin, and 2) …

… and irregular lamellar structure were observed at the top, middle and bottom parts, … is 0.586),
which were guaranteed by the intermetallic compounds and fine eutectic lamellar structure. …

… to produce an ultrafine (α + β) lamellar structure, analogous to that obtained by STA.
Consequently, … The ultrafine lamellar (α + β) structure achieved in this study is analogous to the …

… Additive Manufacturing (AM) of titanium and its alloys … The prior β grains are formed by α-Ti
lamellae and lamellar colonies, … Within the prior β grains, α-Ti lamellae structure is the result …

… α + β lamellar structure, equiaxed α with retained β to a bimodal structure. For Ti-6Al-4V …
directly produces a more desired near-equilibrium lamellar α + β microstructure in situ in the …