… to fabricate high-density stainless steel 316L (SS316L) parts via selective laser melting (SLM).
It aims to improve the production rate while maintaining a low porosity for the SLM-built …

… two representative nonporous 316L stainless steels prepared … was similar to that of wrought
316L stainless steel, which is a … of porous 316L stainless steel scaffolds with highly porous …

… Abstract: llighly porous 316L stainless steel parts were produced … Porous 3 1 hL stainless
steel suitable for medical applications … The specimens with a low porosity of 40% show the high …

… In this study, 316L stainless steel was fabricated by selective … microstructure and porosity
characteristic of SLM 316L SS … on the surface of low porosity sample was more stable and …

… The increased ductility of the third group of sample with 12.29% porosity can be explained
as a result of the low porosity, the high amount of sinter neck formation, the regular spherical …

… Under a relative lower scan speed, the as-received contour outline of molten pool is big …
Thus, a structure with a low porosity tends to be formed, as illustrated in Fig. 8(a). According to …

… The highest porosity content in the concentrated regions was found to be ~1.68% … low
porosity content does not show an obvious impact on the mechanical properties of the AM 316L …

… In this study, gradient porous Ti deposits on 316L substrate … stainless steel 316L substrate
to create the Ti porous coating … to induce the porous layer with the lower porosity than the …

… porosities occurred among powder particles. As a result, fatigue strength of these groups
is quite lower … Also regular porosity structure and low porosity ratio are seen. Despite this, …

… is to investigate and characterize the porosity, microstructural and … Steel AISI 316 L component.
Microscopy and X-ray tomography were employed to study the characteristics of porosity …