… Mg-Ca alloy sheets with high toughness and corrosion resistance were developed by tailoring
the microstructures of Mg-Ca alloys with Ca … Refinement of Mg 2 Ca phase to submicron …

… 0.2, 0.5, 1.0 wt%) were studied at room temperature. Ce additions to ternary Mg-Sn-Ca alloy
… of second phase from CaMgSn to (Ca, Ce)MgSn and Mg 12 Ce. The volume fraction of …

… is the optimized composition to achieve the highest age-hardening repose in the Mg–0.3Ca–xZn
(x = 0.0, 0.1, 0.3, 0.6, 1.0, 1.6 at.%) alloys. The ordered monolayer GP zones are formed …

… Sn-0.5Zn-0.5Ca (all in wt%) alloy sheets were investigated … that the Mg-1.0Sn and Mg-1.0Sn-0.5Zn
alloys exhibited … the Mg-1.0Sn-0.7Ca and Mg-1.0Sn-0.5Zn-0.5Ca alloys showed …

… master alloy were used to prepare the Mg–6Al–1Ca (wt%) alloy. The raw materials were …
and a cross-section of 1.0 × 1.0 mm 2 had been extracted from the Mg–6Al–1Ca extruded bar, …

… This study aims to prepare calcium phosphate coatings on AZ31 and Mg–1.0Ca alloys by
way of electrochemical deposition and compare their different bio-degradation behavior by …

… The results show that a magnesium alloy with 0.6 wt.% calcium content (denoted as Mg–0.6Ca) …
Our preliminary results demonstrate a good potential of this Mg–0.6Ca alloy as a new …

… In this paper, Mg–1.0Zn–0.5Ca alloy with superior mechanical properties … Mg–1.0Zn–0.5Ca
alloys were studied in detail. Mg–Zn–Ca alloy with a nominal chemical composition of Mg…

… The Mg–0.79Ca alloy had the highest hardness, ultimate … with the Mg–0.54Ca and Mg–1.35Ca
alloys, representing the … rate among alloys with 0.3, 0.5, 0.7, 1.0, 2.0 and 5.0 wt% Ca. …

… Mg-0.4%Zn-1.0%Zr-1.5%Ca-2.0%RE alloy to reduce the cost. It is also expected that Ti addition
to Mg-0.4%Zn-1.0%Zr-1.5%Ca (wt.%) alloy is … and properties improvement of the alloys. …