… Mg 2 Ca phase in the tested alloy [12]. Also, Aghion et al. supported the beneficial effect of
0.4 wt% Ca addition on Mg–Nd–Y–Zr alloy … characterize a Mg–Ca alloy at low Ca percentage (…

… Mg and the Mg-Ca alloy with increasing temperature from 223 K to 373 K (–50 C to 100 C).
For the Mg-Al alloy, … In Figure 8, the maximum solute concentration of Mg-Ca alloy is set to 1.0 …

… Five different binary magnesium-based implant materials with increasing calcium content
(0, 0.6, 0.8, 1.0, and 1.2wt% Ca) were produced at the Institute of Materials Science of the …

… Mg–Zn–Ca alloys have attracted much attention due to their low cost and superior mechanical
properties; Zn and Ca, together with Mg… is below 1.0%, while a large quantity of Ca 2 Mg 6 …

… newly developed Mg–9.8Sn–1.2Zn–1.0Al alloy (308 MPa) and Mg–6Zn–0.4Ag–0.2Ca–0.6Zr
alloy (288 MPa) [13], [51]. Moreover, the amounts of Sn (only 2 wt.%) and cheap element of …

… Mg‒Zn‒Ca alloys (Mg-3.2Zn-1.6Ca at 150C, 175C, 200C and 225C; Mg-1.05Zn-0.5Ca and
Mg-1.9Zn-0.3Ca … Ca 2 Mg 6 Zn 3 , while the precipitation of Mg 2 Ca had no or little effect (in …

… [12] reported that adding 1.0 wt.% Sn to ZA84 … could improve the fluidity of the alloys.
Among the Ca-contained alloys, the Mg-4.2Zn-1.7Ce0.8Zr-0.2Ca alloy exhibited the optimum …

… [18] prepared Mg–1.0Zn–0.5Ca alloy by extrusion at different temperatures, resulting in a …
on low-alloyed Mg–Zn–Ca alloys are rare, especially for low-alloyed as-cast Mg–Zn–Ca alloys. …

… With manganese dope into Mg–1%Al–0.8%Ca alloy, the hardness and the specific electrical
resistivity increase in a quenched state. During the ageing process, the hardness increases…

… Mg addition content was approximately 1.0 wt% in Zn-Mg … Zn-0.6Mg alloy with Ca addition
than that of Zn-0.6Mg alloy through … properties of Zn-Mg-Ca alloy, the microstructural evolution, …