… sheet samples by binary Zn–Mg alloy with low and high Mg and a ternary Zn–Mg–Al alloy, …
Formation of MgZn 2 has been observed on the top surface and through the cross-section of …

… and formability of the cold-rolled Mg–Li–Zn alloy sheets with two different Li contents.
Uniaxial … The test results indicated that the Mg–Li–Zn alloy with a Li content of 6 wt% exhibited …

… The stretch formability of a rolled Mg-1.5Zn-0.1Ca alloy sheet was … rolled Mg-1.50mass%Zn
alloy (Mg-1.5Zn alloy) was processed by the same manner with the rolled Mg-Zn-Ca alloy. …

… The microstructures of these rolled sheets consist of fine … The sheets exhibit an excellent
ultimate elongation of ∼50% … The flow curves of the two Mg–Gd–Zn alloys sheets display a …

… Mg alloys including Mg-Zn alloys. Although there is no information available on the effect
of Zn content on texture, a comparison of the similar Mg-Zn alloys with different Zn content, …

… of the DSR processed AZ31 Mg sheets were investigated and it was … the Mg alloy sheets
are still remained unclear. In this study, the DSR processing was carried out on an AZ31B alloy …

… This gives rise to the poor ductility of polycrystalline Mg and its alloys. Furthermore, for rolled
Mg alloy sheets, the basal plane is strongly distributed parallel to the sheet plane. In such a …

… In this study, the microstructure and mechanical properties of MgZnY alloy sheets were
… direction of Mg 98 Zn 1 Y 1 -, Mg 96 Zn 2 Y 2 -, and Mg 94 Zn 3 Y 3 - alloy sheets and their …

… In this paper, the rolling textures of six magnesium alloys containing different levels of zinc
… with the sheet normal direction is lower for RE-containing alloys than for conventional alloys. …

… Sheet magnesium is currently being tested in various application areas, especially in thin
components with large surface areas. However, the rolled Mg alloys often exhibit relatively low …