… gas flow rate and marker retention time, control experimental setup, temperature measurement,
and inlet and outlet gas … dissolving certain weights of PMMA and PVC in the THF solution …

… The mass concentration of PE, PVC, PP, PS and PMMA was between 0.1 … gas
chromatography–mass spectrometry can be used to identify and quantify PE, PP, PVC, PS, and …

… PMMA and PVC yield miscible blends [52]. However, it was reported that PVC–PMMA blend
surface was PMMA-… transition temperature (this is the case of PMMA and PVC in this work). …

… of the enrichment procedure towards the isolation of PVC from a mixture of THF soluble
polymers, 100 μl of a 10 mg/ml standard mixture of PVC, PS, SB, PMMA and PC was spiked on a …

… Nearly all selected NPs could be detected in the surface water at all locations, while PVC,
PMMA, PS, and PET NPs were frequently below the detection limit in the groundwater. PP (…

… out a comparative study of PVC/MMVP blends by inverse gas chromatography (IGC) and …
on PVC was found to be significant with 10 wt % PMMA matrix. Concerning the PVC/PMMA …

… In this work, the extraction and detection of PMMA and PVDC … The GC-MS total ion
chromatogram (Figure 1b) displays that … of PMMA, MMA was considered as the indicator of PMMA. …

… five different plastics (PS, PE, PVC, PP, and PMMA) was successfully applied to the edible …
PVC was the only plastic detected in all of the species analyzed (0.3–75 μg g –1 ). PMMA (0.7…

… PVC, PS and PMMA were separately used as the coating polymer in this study for the following
reasons. PVC … When heated at high temperatures, PS and PMMA degrade to a few kinds …

… PVC could be detected in individual samples although only one sample reported quantifiable
concentrations for both PE and PVC. … 100 ng/mL (PMMA) to 825 ng/mL (PVC) and recovery …