… Rapid adsorption of hazardous anionic dyes sunset yellow (SY), eosin B (EB) in the presence
of cationic dye … time, adsorbent dosage and initial dye concentration was well studied and …

… has been used for removal of dye pollutants from binary systems including methyl orange …
dyes concentrations. The results show that OMA is a good adsorbent for rapid removal of dyes (…

… to adsorb halogenated organic dyes. The synthesis of partially exfoliated graphene (PEG)
showed the ability to adsorb the organic dyes at … The adsorptive behavior of partially exfoliated …

… rapid development of chemical industries over the past decades has fabricated massive
chemical pollutants, … Among these chemical pollutants, the organic dyes are the most frequent …

… dyes adsorbed increased with reaction time until the equilibrium was reached. Initially, the
rate of adsorption increased rapidly … a source of pollution to adsorbents of dye from wastewater…

… 2c, the adsorption capacity rapidly increased with the dye concentration at low … , the
adsorption capacities for the cationic dyes are higher than those for the neutral and anionic dyes at …

… dramatical release levels of hazardous organic dye pollutants threatening public health and
the … Consecutive rapid adsorption experiments of the binary-dye system were performed by …

… groups and developed for removing basic dye pollutants, eg, Methylene Blue (… adsorption
capacity, extremely rapid adsorption rate and separation convenience for basic dye pollutants …

… adsorption capacity for removal of dye pollutants from aqueous solution. The removal percentage
of dyes … % after 6 min which means that the dye removal is too fast in comparison to the …

… The adsorption equilibrium time for CR was 30 min, which was more rapid than those of …
-CS-LS composite exhibited a high adsorption performance for dyes because of the synergistic …