In this study, an ultra-high yield strength (~ 417 MPa) and moderate ductility (~ 12.9%) was
obtained in Mg–8.2 Gd–3.8 Y–1.0 Zn–0.4 Zr (wt%) alloy through a method of decreased …

Here we reported a heterogeneous fiberous structured Mg-5.6 Zn-0.6 Zr (wt%) alloy
obtained by conventional extrusion method, which exhibited high yield strength of∼ 345 …

The effects of small additions of calcium (0.1% and 0.5% 1) on the dynamic recrystallization
behavior and mechanical properties of as-extruded Mg-1Mn-0.5 Al alloys were investigated …

Abstract The effect of Ca/Al ratio on microstructure and mechanical properties of the as-cast
and as-extruded Mg-Al-Ca-Mn alloys were investigated. The as-cast Mg-Al-Ca-Mn alloys …

A high-strength low-cost Mg–2.5 Zn–0.3 Ca–0.4 La (mass%) alloy was fabricated by hot
extrusion following direct-chill casting. Yield strength (YS), ultimate tensile strength (UTS) …

In our previous work, we designed a new as-cast Mg–Y–Zn–Al–Li alloy with a high elastic
modulus of 52.9 GPa. The alloy was further subjected to hot deformation under different …

Commercial wrought Mg alloys normally contain low alloying contents to ensure good
formability. In the present work, high-alloyed Mg-6Al-4Zn-xSn (x= 1, 2 and 3 wt …

This work systematically investigates the impact of the dilute Sc addition on microstructures
and mechanical properties in Mg alloys. Electron back scattered diffraction, slip traces …

The microstructure and mechanical properties of Mg–Zn-0.5 Ca-0.5 RE magnesium alloy,
with zinc contents of 0, 2, 4, and 6 wt%, were studied. A significant effect of Ca and rare earth …

Through studying the effect of initial microstructure on the precipitation behavior,
microstructure evolution and mechanical properties of Mg-6Gd-4Y-0.5 Zn-0.5 Zr alloy, an …