In this paper, the effects of Zr, Sc and Ce additions on the as-cast microstructure and
mechanical properties of Mg–3Sn–1Mn (wt.%) magnesium alloy were preliminarily …

The microstructure and mechanical properties of Mg-xSn (x= 3, 7 and 14, mass fraction,%)
alloys extruded indirectly at 300° C were investigated by means of optical microscopy …

The Mg–3Sn–2Ca–xCe (x= 0–2.0 wt.%) alloys were prepared by permanent mould casting
method, the effects of Ce on the as-cast microstructure and mechanical properties of the …

In this paper, the effects of minor Ti addition (0.1–0.3 wt.%) on the as-cast microstructure and
mechanical properties of Mg–3Sn–2Sr (wt.%) magnesium alloy are investigated. The results …

The strontium (Sr) addition to the Mg–5wt.% Sn alloy results in grain refinement and the
formation of a rod-shaped and a bone-shaped MgSnSr intermetallic phase which are mainly …

Commercial wrought Mg alloys normally contain low alloying contents to ensure good
formability. In the present work, high-alloyed Mg-6Al-4Zn-xSn (x= 1, 2 and 3 wt …

In this study, enhancement of mechanical properties of Mg-5Sn-3Zn alloy was achieved by
alloying with Ca, and the strengthening response due to coarse CaMgSn, nano and micro …

Abstract The effect of Sn, Ca, Al, Si and Zn addition on the compressive strength of cast Mg–
Sn–Ca (TX) alloys was studied in the temperature range of 25–250° C and correlated with …

We investigated the effects of Ag addition on the microstructure and mechanical properties
of hot-extruded Mg–6Zn–2Sn–0.4 Mn-based alloys. Ag addition resulted in the formation of …

The effects of Ca addition on the as-cast microstructure and mechanical properties of the Mg-
5Zn-5Sn (mass fraction,%) alloy were investigated. The results indicate that an addition of …