In the melt spinning of high molecular weight poly (ethylene terephthalate), the spinline
immediately below the spinning nozzle is heated by irradiating the CO2 laser in order to …

In the melt spinning of PET, effects of the variation of flow behavior in the vicinity of spinning
nozzle on the mechanical properties of as-spun fibers and drawn fibers were investigated …

Poly (ethylene terephthalate)(PET) fiber is obtained by polystyrene (PS)/PET sheath/core
conjugate melt spinning and removal of the PS component. The fiber is drawn under heating …

We determined that a poly (ethylene terephthalate) microfiber was easily obtained by
irradiating a carbon dioxide laser to an annealed fiber. The annealed fiber was prepared by …

High‐speed melt spinning of poly (ethylene terephthalate) was performed using a spinning
nozzle with an inserted metallic wire of various lengths (0, 8, 30, and 45 mm). The molecular …

The process of melt‐spinning poly (ethylene terephthalate)(PET) filament at high speeds
was modified through the inclusion of a liquid isothermal bath (LIB) in the spinline. A wide …

An investigation involving 6000 m/min spinning process is undertaken on poly (ethylene
terephthalate) in this study. Experimental results indicate that the physical properties of the …

Four kinds of ethylene terephthalate/ethylene isophthalate copolymers (PET/PEI, PEI= 0, 2,
5, 10 mol%) were prepared and melt spun at take-up velocities from 1 to 7 km/min …

On‐line measurement was performed in the high‐speed spinning of flat, hollow, and circular
fibers of poly (ethylene terephthalate), paying particular attention to the change in cross …

The effect of poly (ethylene terephtalate)(PET) polymers with different rheological properties
as well as the effect of different spinning conditions on the minimum attainable takeup denier …