A series of Al x CrCuFeNi 2 (labeled Al 0, Al 0.5, Al 0.75, Al 1.0) high entropy alloys (HEAs)
were additively manufactured via selective laser melting, with emphasis on the influence of …

An equiatomic AlCrCuFeNi high entropy alloy (HEA) is fabricated successfully from the alloy
powders using selective laser melting (SLM). Microstructural characteristics and mechanical …

Preparing dual-phase high-entropy alloys (DP-HEAs) by selective laser melting (SLM) has
never been achieved owing to high crack susceptibility induced by rapid solidification. Here …

The present study focused on changes in the microstructures and mechanical properties of
AlCoCuFeNi high-entropy alloy (HEA) fabricated via selective laser melting (SLM) and …

An equimolar hexahydroxy AlCoCrCuFeNi high-entropy alloy (HEA) was produced by
selective laser melting (SLM) gas-atomized powders, with emphasis on investigating its …

In this work, the AlCoCrFeNi 2.1 eutectic high-entropy alloys (EHEAs) were fabricated by
laser additive manufacturing and subsequently heat-treated at various temperatures …

In this work, high strength and ductile Al0. 5Cr0. 8CoFeNi2. 5V0. 2 high-entropy alloys
(HEAs) were fabricated by the selective laser melting (SLM) technique. After orthogonal …

An AlCrCuFeNi 2 high entropy alloy (HEA) was prepared by arc melting, followed by
annealing at different temperatures. The elemental distributions, phase formation …

Abstract The Al 0.5 CrCuFeNi 2 HEAs with three different statuses (as-cast,-rolled, and-
annealed) are prepared to investigate their microstructure evolutions and tensile behaviors …

In the present study, the evolution of microstructure, texture and high-temperature
mechanical behavior of the additively manufactured (AM) eutectic high entropy alloys …