Effects of the molecular weight (intrinsic viscosity) of poly (ethylene terephthalate) on the
formation of fibers and their properties are analyzed. Correlations between molecular weight …

High molecular weight poly (ethylene terephthalate)(PET, IV= 3.30 dL/g) was extruded in
attempts to prepare high performance fiber using the solution spinning method. Solution …

High‐strength poly (ethylene terephthalate)(PET) fibers were obtained using low molecular
weight (LMW) polymervia horizontal isothermal bath (hIB), followed by postdrawing process …

The effect of poly (ethylene terephtalate)(PET) polymers with different rheological properties
as well as the effect of different spinning conditions on the minimum attainable takeup denier …

The structure and properties of fibers prepared from copolymers of poly (ethylene
terephthalate)(PET) in which 2‐methyl‐1, 3‐propanediol (MPDiol® Glycol is a registered …

Influence of spinning velocities on the mechanical and structural properties of polyethylene
terephthalate (PET)/nylon 6 blend fibers have been reported. Fibers of PET/nylon 6 …

A wide range of polyethylene terephthalate fibres was prepared by melt spinning to different
degrees of molecular orientation. The tensile drawing behaviour of these fibers was then …

Modification of the threadline dynamics has effected significant alternations in the structure
and improvements in the properties of high‐speed melt spun poly (ethylene …

A series of branched poly (ethylene terephthalate) samples was prepared by employing
0.07–0.42 mol% trimethylolpropane (TMP) for melt polycondensation. These polymers were …

Fiber spinning of polyethylene terephthalate (PET) was studied at take‐up speeds ranging
from 2000 m/min to 7000 m/min under various spinning conditions. Effects of changes in …