… This device is useful for the investigation of repetitive … signal is amplified and rectified
with apparatus identical to that described above for the signal from the electronic time switch…

… control signal to the drive voltage with an amplitude of +15 V to control the solid-state switch.
… Wang, “The development of solid-state nanosecond pulsed plasma jet apparatus based on …

… switch unit that is involved with the voltage amplitude, rise/fall time, pulsewidth, and repetition
… same timing as the control signal to open and close the solid-state switch. To obtain a short …

… switch was tested using a simulation technique in which the switch was subjected to the same
repetitive … of switch performance as a function of air flow rate and peak voltage have been …

… large dimension of power apparatus and attached power lines… disturbances are narrow-band
signals, which are caused by … PD signals by comparing successive cycles of the PD signal. …

… section switch box (optical signaling) followed by acoustic signals from the relief … repetitive
relays, RKMP and RKMM, which send the information to the command and control apparatus. …

… The repetitive input signal to the transformer T2 (Fig. 6) controlled by the IGBT switch is …
Components such as a peaking switch, a repetitive trigger switch, and an IGBT switch simplify the …

… a repetitive impulse switching device with a frequency control system, a turbo-… a trigger
signal was input to the first gas gap switch, the switch was closed, and the second gas gap switch, …

… electric equipment, under operational conditions, with regard to repetitive damped oscillatory
waves occurring mainly in power, control and signal cables installed in GIS. According to it, …

… when the conventional TOF signal showed very little evidence of … to expensive lasers and,
using TTL signals, to switch 'on' and 'off… Repetitive mode TOF operation leads to space-charge …