… When a strip of a filler-reinforced rubber vulcanizate is extended to a given elongation, …
changes in room temperature electrical resistivity observed on stretching a strip of rubber to …

… (70 N-phenyl-P-naphthylamine (PBN) at room temperature till equilibrium swelling. The …
The volume fraction of rubber in the swollen vulcanizate (V,) was then calculated using the …

… The range of temperature at present available is not sufficient for a thorough examination of
… rapidly troublesome above room temperature. As expected, raising the temperature from 30 …

… of a vulcanizate prepared from the degraded natural rubber was the same as that prepared
from the source rubber, … Tensile test was carried out at room temperature using an Instron …

… to different temperatures in the molder and then cooled to room temperature at different
speeds. The XRD data for trinylon molded at 170C and slowly cooled to room temperature [Fig. 6(…

… resulting NR vulcanizates compared to the gum vulcanizates. … of NR vulcanizates are strongly
affected by the filler–rubber … were immersed in toluene at room temperature for 72 h. The …

… The dynamic properties of rubber are altered tremendously by the … of rubber vulcanizates
with carbon black as a filler. The effect covered in this article are important in designing rubber …

… smoked sheet rubber that … at room temperature was determined to insure that our samples
had not changed since their preparation. By using the values of the volume fraction of rubber …

… Hot-air aged specimens were stored at room temperature for 2–3 h for further analysis. …
The specimens after tensile fatigue were stored at room temperature before further analysis. …

… NR vulcanizates, carbon black filled NR vulcanizates, and silica-filled NR vulcanizates will
… The specimens after tensile fatigue were stored at room temperature before further analysis. …