… of the column walls from the tensile or compressive force of the beam flange. This paper
includes tests of one side bolts, material tests of the connection part where the column thickness …

… and in compressive side, simplified connection tests as shown in … SHS column near the
connection is reinforced by four 25mm thick steel angles. The angles are fillet welded to the SHS …

… Section (SHS) columns and a complete assembly process are proposed in this paper. A
total of six full-scale Thread-fixed One-side Bolts (TOBs) bolted beam to SHS column joints with …

… bolts that can be installed only from one side can be used. A new type of blind bolt, the headed
stud anchored blind bolt, … This type of blind bolt, in addition to bearing on the tube wall, is …

… of T-One-side bolt stub connections using the same type of bolts. In the current study H … a
SHS column using end-plates with one side bolts. Around the connection area, the SHS column …

… to the blind bolted connections to SHS columns in … -side bolting, nowadays has made it
possible to overcome the difficulties in the installation of bolted connections to SHS columns with …

… column via the diaphragms using either bolted or welded connections (or a combination of
the two approaches). SHS/… at the two sides of the column (ie ‘east’ and ‘west’ sides for ease of …

… blind bolts to connect I-beams to concrete-filled steel square hollow section (SHS) columns.
… Their initial rotational stiffness is dominated by the stiffness of the column flange in bending, …

… above beam-to-column connections was examined based on open-sided module during
road … to go through the SHS column via the clearance of the bolt holes. The bolt direction was …

… SHS Column using an innovative fastening solution with the commercial designation of
hollo-bolt. … access is possible from one side only. This is particularly useful for nodes in which the …