… Figure 9 compares the corrosion rates of all of the surface modification strategies
employed in this study. The comparison reveals that the corrosion rates of the surface-treated …

… of corrosion towards the implant and human body and the mechanism to improve it. Due to
this corrosion delinquent, several surface modification … , the acceptable corrosion rate for …

… surface modification techniques is illustrated in this review as suggested by many research
groups. Also, this article includes the corrosion behavior of surface-modified … , corrosion rate …

… area obtained by acid etching could influence the corrosion … the surface microstructures and
accelerate the corrosion rates of … surface textures, chemical etching is used to create surface …

… The general corrosion rate profiles for various surface conditions in boiling 10% HCl
solution are tabulated in Table 1. It can be seen that both TO and PTO treatments offer superior …

… saline solutions showed an increase in the corrosion rate of titanium with increasing peroxide
… It was found that corrosion reduced the hardness of surface oxides in all of the alloys. The …

… The experimental results show that the corrosion rate, … corrosion resistance becomes better
than that of TiAl under the prevailing conditions. For the AISI H13 tool steel, the corrosion rate …

… protection was achieved using the concentrations of 14 and 20 mol L − 1 and 24 h of treatment
time, resulting in corrosion rates 20 times lower than those of untreated samples. These …

… They performed Tafel analysis for Icorr, Ecorr and corrosion rates for bare and the laser
treated specimens and found that the TiO2 nanoparticle-coated Ti–6Al–4V is more …

… Corrosion rates of the initial and modified Mg-Gd-Ca alloy samples were measured by
immersion test in HBSS for 2 h, 1 day, 3 days, 7 days and 14 days. After immersion, …