… The upstream receiver has to acquire synchronization to each incoming burst very quickly
and decode the payload correctly. This paper presents a universal burst receiver which …

… bursts with phase synchronization between bursts, if the estimate of the frequency is close
enough there may be no need for frequency locking at the receiver. … only assume that bursts of …

… Unlike a continuous receiver, if the burst receiver is not able to … 2 cable must supply a
variable gain of 50dB, from +8 to +58dBmV of signal level. Common practice is to design the burst …

… Defining the loud/soft ratio as the ratio between power levels of the strongest and weakest
bursts in the system, the EPON standard requires a high loud/soft ratio to allow for flexible …

… Each cable modem connected to the coaxial bus needs to undergo a start-up procedure at
… The upstream frame used is designed for use with a burst-mode QPSK receiver, and can …

… This paper presents an architecture for Burst Switching Systems designed to switch data …
The choice of methods has a very large impact on the time required for a receiver in a burst-…

… the development and test of a Burst Mode Receiver (BMR) chip for PONs (… receiver chip.
This combination of an analog amplifier and a digital receiver and control unit is called a System …

… the digital systems lead to the fact that costeffective receivers can … systems to be implemented
in the multistandard receiver, this … Each time-slot (burst) is transmitted at a gross bit rate of …

… by cable modem termination system (CMTS). The transmitted upstream packets have a burst
nature … In this paper, we propose the structure of the CM receiver supporting four upstream …

… Furthermore, the home network is about to explode with … services, specifically modern cable
modem systems, share common … Along the feeder cable, line extender amplifiers are used to …