… isolator based on a new concept using a section of axially magnetised ferrite coupled line (…
, LE: ‘Normal mode analysis of ferritecoupled lines using microstrips or slot-lines’, IEEE Trans. …

… a three- and four-port “microstrip” circulator with the ferrite above the substrate. However,
multiple reflections were observed and the differential isolation was poor (approximately 6 dB). …

… isolation in comparison to a single ferrite coupled line structures. In this paper, we propose
an alternative cascade of sandwich microstrip ferrite coupled line … of double isolators were …

… coupled-mode approach is applied to a microstrip circulator with a distributed section of axially
magnetized ferrite coupled lines (… The measured isolation is closer to our theoretical value …

… This paper demonstrates the versatility of ferrite isolators as tunable … 50 microstrip lines on
the same ferrite substrate. The transition to RWG is made by flaringout the microstrip line such …

… The integrated nonreciprocal devices are in general realized in microstrip [2–12] or slot line
[15… The investigated structures of FCL circulator and double isolator were manufactured and …

… coupling between the basis propagating and the evanescent isotropic modes, we determine
the propagation characteristics of normal modes in ferrite microstrips… The isolation of the port …

… The effect of variation of the bias field toward differential isolation … [6] CS Teoh and LE
Davis, “Normal-mode analysis of ferrite-coupled lines using microstrips or slotlines,” IEEE Trans. …

… The design and simulation are based upon a simple three-port microstrip ferrite coupled
line … From the results of the HFSS simulations, we report isolation as high as 52 dB and an …

… For FSL, the focus is on microstrip lines with longitudinally-magnetized ferrite, as an important
… ® Figure 2.4: Side view of coupled-slot finline isolator with one ferrite slab placed on each …