… stretched film was 1 W m −1 K −1 , which was twice higher than that of the solution-cast film,
while … films and cast films. This was consistent with the results observed by thermal imaging. …

… was dissolved in 20 ml DMF followed by precipitation in an excess mixed solvent … polymer
films were prepared via solution-casting methods according to the literature 18 . The polymer …

… The tape-casting slurry were prepared by mixing the pure PLZS powders with solvent (ethanol …
Then, the obtained slurry was cast onto the PET film using a tape-casting machine. The …

… dielectric properties and subsequent electrocaloric effect, whereas … polymer solution was
cast onto clean glass plates and then dried at 70 C for 2 h in an oven to evaporate the solvent…

… was prepared through casting. The nanocomposites with PBZ nanofibers of 3 vol% showed
… PVDF polymers dissolved in an organic solvent. Flexible PBZ/PVDF composite film with …

… -cast the P(VDF-TrFE-CFE) solution onto a glass substrate, and the resulting polymer film was
… solvent, raise the degree of crystallinity (see fig. S2), and enhance the polarizability of the …

… Here, we demonstrate an interpenetrating architecture of electrocaloric polymer with highly
… cast onto a glass substrate and placed in an oven at 60 C for 24 h to remove the solvent. …

… polymerization process by Piezotech (France). The films were fabricated using a solution-cast …
C for > 10 h to increase crystallinity and further remove the residual solvent. Some of the …

The electrocaloric effect (ECE), which refers to changes in the temperature of a material when
an electric field is applied to or removed from the material, is one of the key phenomena of …

… We did not fabricate thinner films with larger breakdown fields, in view of the following …
thinner (|ΔT| ∼ 5 K due to 89.5 V μm −1 across 350 nm at 333 K). However, our tape-cast films …