The strain dependency of the stiffness of bonded and free-standing thermal barrier coatings
(TBCs) was analyzed using four point bending. The deformation in top and side face of the …

The stiffness of air plasma sprayed (APS) thermal barrier coatings (TBCs) was determined
from bending experiments combining strain analysis on a microstructural level with …

Thermal spray coatings (TSCs) have complex microstructures and they often operate in
demanding environments. Plasma sprayed (PS) thermal barrier coating (TBC) is one such …

A modified analytical model has been developed to describe the nonlinear elastic response
and residual stress in plasma sprayed thermal barrier coatings (TBCs) on the basis of the …

In this work, the stiffness of an air plasma sprayed thermal barrier coating (APS TBC) was
studied using the three-point bending technique. Various measurements over different time …

The primary intention of this work is to investigate the thermo-mechanical buckling
delamination failure characteristic of air plasma sprayed thermal barrier coatings (TBCs) …

It has been acknowledged that stresses within a thermal barrier coating (TBC) and its
durability are significantly affected by the coating interfaces. This paper presents a finite …

Thermal barrier coatings consisting of a NiCrAlY bond coating and a 1.4 mm thick partially
stabilised zirconia top coating were air plasma sprayed onto grit blasted nickel-base …

Stabilized zirconia coatings are used as thermal barrier coatings (TBCs) because of their
ability to improve the performance and efficiency of gas turbine engines by allowing higher …

Yttria-stabilized zirconia coatings were deposited by plasma spraying and heat-treated at
1100° C for 50, 100, 150, and 200 h in air, respectively. Mechanical properties including …