The above mentioned devices form a standard DSC, which has 8 Mbyte of memory and runs
at 25MHz. The Tandberg TDV2200S can be used as system terminal (available at no cost …

The model V260 is a 1-unit wide VME module provided with 16 independent 24-bit counting
channels operating at the guaranteed input frequency of 100MHz. The module houses a …

The DSC hardware and the management of the configuration: Each DSC in the PS control
system is based on a specific hard ware configuration and runs a dedicated set of …

The interface between the DTE (data terminal equipment, eg, terminal or computer) and the
DCE (data circuit terminating equipment, eg, modem) is of fundamental importance in data …

To face this situation we have had to define adapted means to manage the DSC's hardware
configuration and the associated start up procedure. This management is based on the use …

This article features MAX 187, a 12-bit A/D converter (ADC). You can create an interface to
this ADC using serial data-communications techniques. Analog-to-digital conversion and …

4.1 General 4.2 CPU timing 4.3 Clocking concept with prescaler PSC 4.4 32 kHz Real-Time
Clock 4.5 Memory organization 4.6 Addressing 4.7 I/O facilities 4.8 Timer/event counters 4.9 …

I use a microcomputer primarily as a means of developing sof-tware and of writing long docu-
ments, such as this article. My SC84 computer gives better performance than many other …

This application report describes the way to interface the TMS320CX54x digital signal
processor (DSP) with an I2C device. The setup uses the multichannel buffered serial port …

Design of a DSP-system is an interaction of both hardware and software design and to
manage this process a proper real time debugging tool is needed. During a period of more …