This application report describes the way to interface the TMS320CX54x digital signal
processor (DSP) with an I2C device. The setup uses the multichannel buffered serial port …

ABSTRACT The TMS320C6000 multichannel buffered serial port (McBSP) can operate in
a variety of modes, as per application requirements. For proper operation, the serial port …

This document describes how to use the multichannel buffered serial port (McBSP) in the
Texas Instruments (TI™) TMS320C6000 digital signal processors (DSP) to interface to a …

This application note describes the implementation of the PICmicro MSSP module for Master
I2C communications. The Master Synchronous Serial Port (MSSP) module is the enhanced …

From the Book: PREFACE: Preface Digital signal processing techniques are now so
powerful that sometimes it is extremely difficult, if not impossible, for analogue signal …

This paper describes a specific 8-bit data interface circuit for the digital signal
microprocessor TMSC320C31 from Texas Instruments. This DSP can be connected to any …

This paper introduces some applications in digital signal processing (DSP) using the Digital
signal processing Starter Kit (DSK). The DSK is based on Texas Instruments' TMS320C31 …

Figure 1. The 320C80's four DSPs and its RISC master processor all share the chip's on-
board RAM via a crossbar switch. The transfer controller (TC) acts as an intelligent DMA …

The 32 channels TDC VME board is a 6U VME module based on the KLOE TDC integrated
circuit. So, it inherits all the ASIC's speci cations adding the on-board facility of setting the …

This application report presents a hardware solution for interfacing the TLV1571/TLV1578
10-bit, 1.25 MSPS low-power analog-to-digital converter (ADC) to the 16-bit fixed-point TMS …