The research was devoted to studying unlubricated tribological behaviors of γ-TiAl-based
coatings in the temperature range 25–400° C. These γ-TiAl-based intermetallic coatings …

Substrates of Ti-based coatings were investigated regarding wear resistance and
refractoriness. Substrates with and without the TiAl 3 coating formed by the ion plating …

Abstract Intermetallic Ti-Al-Cr based coatings with small additions of yttrium or zirconium
were deposited on the γ-TiAl alloys Ti-48-2-2 and TNM-B1 using magnetron sputtering. The …

Intermetallic Ti–Al–X (X= Cr, Nb) coatings were deposited on conventional near-α titanium
alloy TIMETAL 1100 and on γ-TiAl based Ti–48Al–2Cr–2Nb by magnetron sputtering for …

Intermetallic Ti-Al coatings were deposited onto near-α titanium alloy TIMETAL 1100 using
magnetron co-sputtering technique. Two coating systems were investigated: gradient layers …

TiAl-based intermetallic layers with additions of Ag, Cr, Y and Hf were deposited on γ-TiAl
specimens using magnetron sputtering. The oxidation behaviour of the coated Ti-45Al-8Nb …

A two-layer TiAl/TiAlN coating was deposited by High Power Impulse Magnetron Sputtering
on the surface of three TiAl intermetallic alloys for improving their oxidation resistance. The …

This article describes increasing wear resistance of 5CrNiMo die steel by more than 5 times.
This effect is achieved by creating TiC-Ti-Al and TiB 2-Ti-Al coatings on the surface of …

The rapid progress in engineering enhances the demands set on materials requiring better
mechanical properties, resistance to frictional wear, corrosion and erosion etc. These …

Purpose: Development of an original multiplex hybrid treatment of Ti6Al4V alloy: diffusion
hardening+ intermediate hard gradient TiCxNy layer with use of continuous CAE+ top low …