Deformation-induced austenite to martensite transformation is an important phenomenon
during the deformation of metastable fully austenitic transformation induced plasticity (TRIP) …

An appropriate fraction of a second phase for controlling the dynamic grain growth of the fine-
grained microstructure during hot deformation can be easily achieved for the high and …

The effect of grain size on the mechanical properties of an equiatomic CoCrFeNiMn high-
entropy alloy (HEA) was investigated by shear punch testing (SPT) as a miniature test …

In this research, the experimental investigation of the change of the strain path on the
microstructure, mechanical properties and the forming limit diagram of Al/Mg two-layer sheet …

Abstract Fe–Mn–Al–C austenitic steels have promising prospects for lightweight
applications, due to their low density, excellent strength, and ductility. But the specific …

In present work, tensile behaviors of cold-rolled 304L stainless steel were investigated at
both room temperature (RT) and liquid nitrogen temperature (LNT). After cold-rolling with a …

The prior particle boundaries (PPBs) are a typical powder metallurgy (PM) defect, which
usually leads to the deterioration of mechanical properties in PM materials. In this study, two …

Since cross rolling promotes the transformation of austenite to deformation-induced α΄-
martensite and increases the dislocation density in the retained austenite, the reversion …

Shear cutting is a high-speed forming process where material separation is involved. The
nature of the process leads to high strain rates and temperatures on the sheared zone of the …

The effects of cold rolling routes followed by annealing on the mechanical properties of AISI
316L stainless steel were characterized. Both unidirectional and cross rolling methods were …