Advancing the application of atomic force microscopy (AFM) to the characterization and quantification of geological material properties
Atomic force microscopy (AFM) has been widely used in materials science and chemistry
research since it was invented in the 1980s. It is a relatively new tool for geosciences and is …
research since it was invented in the 1980s. It is a relatively new tool for geosciences and is …
Measurement of residual stresses using nanoindentation method
LN Zhu, BS Xu, HD Wang, CB Wang - Critical Reviews in Solid …, 2015 - Taylor & Francis
Instrumented indentation, which is also known as nanoindentation or depth-sensing
indentation, is increasingly being used to probe the residual stresses of materials including …
indentation, is increasingly being used to probe the residual stresses of materials including …
Influence of equi-biaxial residual stress on unloading behaviour of nanoindentation
ZH Xu, X Li - Acta Materialia, 2005 - Elsevier
Finite element simulations have been used to investigate the influence of equi-biaxial
residual stress on the unloading behaviour of nanoindentation on elastic–plastic strain …
residual stress on the unloading behaviour of nanoindentation on elastic–plastic strain …
A new methodology for measuring residual stress using a modified Berkovich nano-indenter
A Greco, E Sgambitterra, F Furgiuele - International Journal of Mechanical …, 2021 - Elsevier
In this paper, a new methodology, based on nanoindentation, is proposed to estimate the
magnitude and orientation of the principal residual stress components, in a non-equi-biaxial …
magnitude and orientation of the principal residual stress components, in a non-equi-biaxial …
Indentation method to measure the residual stress induced by ion implantation
Q Wang, K Ozaki, H Ishikawa, S Nakano… - Nuclear Instruments and …, 2006 - Elsevier
A depth-sensing indentation system was used to measure the residual stress in a stainless
steel plate implanted by Fe2+ ions with an energy of 3MeV at a dose of 3× 1016cm− 2 …
steel plate implanted by Fe2+ ions with an energy of 3MeV at a dose of 3× 1016cm− 2 …
Microstructural effects on indentation failure mechanisms in TiN coatings: Finite element simulations
Titanium nitride (TiN) coatings offer improvements in resistance to wear and environmental
degradation. TiN films produced by physical vapour deposition tend to exhibit columnar …
degradation. TiN films produced by physical vapour deposition tend to exhibit columnar …
Surface roughness effect in instrumented indentation: A simple contact depth model and its verification
Since in instrumented indentation the contact area is indirectly measured from the contact
depth, the natural and unavoidable roughness of real surfaces can induce some errors in …
depth, the natural and unavoidable roughness of real surfaces can induce some errors in …
Use of nanoindentation to measure residual stresses in surface layers
Equal biaxial residual stresses (of up to about 175MPa) have been generated in thin copper
foils via differential thermal contraction. These foils were subsequently indented, under …
foils via differential thermal contraction. These foils were subsequently indented, under …
A novel method to measure equi-biaxial residual stress by nanoindentation
Background The accurate measurement of residual stresses (RS) is crucial for predicting the
performance of mechanical components, as RS can significantly impact fatigue life, fracture …
performance of mechanical components, as RS can significantly impact fatigue life, fracture …
Indentation and imprint mapping method for identification of residual stresses
M Bocciarelli, G Maier - Computational Materials Science, 2007 - Elsevier
Indentation tests are at present frequently employed for the identification of material
parameters. A recently proposed technique combines the traditional indentation test with the …
parameters. A recently proposed technique combines the traditional indentation test with the …