Obtaining ultra-high strength in commercial ZK60 wrought alloys is rather difficult by
conventional processes due to their limited precipitation hardening. In this work, we …

Achieving ultra-high tensile yield strength over 400 MPa in RE modified Mg–Zn-based alloys
using conventional thermomechanical processing is a challenging task. In this study, we …

In this work, a new Mg-1.6 Sm-0.4 Ce (wt%) alloy sheets was fabricated by extrusion
process, which exhibits the high yield strength of 184 MPa, tensile strength of 222 MPa, and …

In this work, we introduce a microstructure with high-density nano solute clusters by rolling at
100° C to efficiently fabricate a high-strength ZK60 alloy plate. High yield strength of 336 …

In this work, the influence of Mn and Ca doping on the microstructure and mechanical
properties of Mg–3Zn, Mg–3Zn-0.5 Mn, and Mg–3Zn-0.5 Mn-1.2 Ca alloys is systematically …

The effect of twinning and de-twinning on precipitation behavior of a rolled AZ80 alloy has
been examined. Results showed that both twinning and de-twinning deformation can …

Different amounts of La 2 O 3 were added to ZK60 alloy to observe the changes in
microstructure and mechanical properties of ZK60-XLa 2 O 3 (X= 0, 0.2 wt%, 0.5 wt%) …

In this work, a good combination of strength and ductility is achieved in a Mg-13Gd-0.2 Ni
alloy by conventional extrusion and following aging treatment. The aged Mg-13Gd-0.2 Ni …

In this work, a novel low-alloyed Mg-Sn-Li-Al alloy with high-strength has been developed.
The addition of∼ 1​ wt% Li into the Mg-2Sn wt.% binary alloy can change the type of …

Abstract For typical Mg-Zn-Zr alloys, exhilaratingly high strength of a yield strength (YS)
higher than 300 MPa can hardly be attained by traditional rolling. In this paper, we compare …