After decades of developing strategies to minimize the corrosion of metallic biomaterials,
there is now an increasing interest to use corrodible metals in a number of medical device …

This paper studied the microstructure and corrosion behavior of Mg-xSc binary alloy (x= 0.1–
1.5 wt.%) sheets. Sc has a significant effect of refining grains of Mg. The Mg-Sc binary alloys …

Indentation test using a cylindrical indenter with a flat end is now known as impression test.
The advantage is its capability to reach a steady state for creep test at constant load and it is …

Deformation dilatometry and semi-industrial extrusion were used to investigate the effect of
different thermomechanical processing routes on the microstructure and mechanical …

Abstract The Mg-6 mass% Zn alloys microalloyed with different amounts of Ca were cast and
extruded. The second phase in the as-cast Mg-6Zn alloy is Mg 4 Zn 7, which is replaced by …

In this study, the discharge behaviors of extruded low-alloyed Mg–Bi–Ca alloys in an
aqueous electrolyte (3.5 wt% NaCl solution) were investigated using electrochemical …

Abstract Effects of Ca content (0.0, 0.5, 1.0, 2.0 wt%) on the microstructure, texture and
mechanical properties of Mg-1.0 Sn-0.5 Zn-based alloys were investigated. The results …

The microstructural and textural evolutions as well as room-temperature mechanical
properties of three binary Mg–Gd alloys with 1, 2, and 3 wt% of Gd were studied in the as …

The effect of Sn addition on the microstructure and mechanical properties of Mg-12Gd-3Y-
0.5 Zn-0.6 Zr (wt%) alloys was investigated. The results show that the microstructure of the …

The microstructure and mechanical properties of as-extruded Mg-1.0 Sn, Mg-1.0 Sn-0.5 Zn,
Mg-1.0 Sn-0.7 Ca and Mg-1.0 Sn-0.5 Zn-0.5 Ca (all in wt%) alloy sheets were investigated …