In this work, a high-performance Mg-8.4 Gd-4.4 Li-3.5 Y-1.4 Zn (wt%) alloy was successfully
prepared by low-temperature hot extrusion. The studied alloy has a TYS of 295±1 MPa and …

In this study, a high-strength Al–11Si alloy with an improved ductility was developed via a
two-step processing route-equal-channel angular pressing (ECAP) and post-cryorolling …

Non-conventional differential speed and confined hot rolling methods were employed to
process two binary magnesium-aluminum-alloys, Mg-xAl (x= 6 and 9 wt%), with …

A dispersion of Guinier Preston (GP) zones yields attractive mechanical properties in
wrought magnesium alloys. However, the precipitation of GP zones has been reported in a …

A heterogeneous lamella (HL) design strategy was applied to manipulate mechanical
properties of a new cost-effective Fe 35 Ni 35 Cr 25 Mo 5 compositionally complicated alloy …

High-strength Mg alloys have historically suffered from a challenge in achieving good
ductility. Here, we report an asymmetric gradient nanostructure design prepared by …

The discontinuous precipitation (DP) and continuous precipitation (CP) characteristics and
mechanical properties of a AZ80A magnesium alloy aged at 150, 175 and 200° C were …

Abstract The Mg-Sn-Y alloys exhibiting advanced elevated-temperature strength up to 300℃
were newly developed by tailoring precipitates through partially substituting and increasing …

This work systematically studies the dynamic recrystallization (DRX) behavior of as-cast
AZ91 magnesium alloy under hot compression deformation at 350° C. These results were …

In the present study, we investigated the dynamic precipitation (DP) of Mg 17 Al 12 phase
accompanying dynamic recrystallization (DRX) during the deformation of an Mg-Al-Zn-RE …