The present study compares the thermomechanical fatigue (TMF) behaviour of 316L
stainless steel manufactured conventionally by hot rolling and additively by laser powder …

Laser-based additive manufacturing (AM) provides a new pathway for rapid manufacturing
of radiation-resistant materials used in the nuclear engineering system. Ultrafine sub-grain …

In this study, the research on 316L steel manufactured additively using two commercially
available techniques, Material Extrusion (MEX) and Laser Powder Bed Fusion of Metals …

Tests for low-cycle fatigue in the elastic-plastic deformation region of samples made of
09G2S steel prepared on a 3D laser printer by selective laser Melting (SLM-steel) were …

In this study, the research on 316L steel manufactured additively using two commercially
available techniques, Material Extrusion (MEX) and Laser Powder Bed Fusion of Metals …

Considering the relationship between austenite stability and strain level, the cyclic response
curves are obtained for SLM 304L under different strain amplitude at R= 0.3. The results …

This review exclusively covers the quality of parts produced by different powder fed Direct
Energy Deposition (DED) processes. In this paper, the focus is on the parts which are made …

This chapter provides an overview of low-cycle fatigue behavior in additive manufactured
metals, including aluminum alloys, nickel-based superalloys, titanium alloys, maraging …

采用激光熔化沉积技术制备JBK-75 合金, 选取750℃ 直接时效和1180℃ 高温固溶+ 750℃
时效两种不同热处理工艺路线, 分析了其沉积态的显微结构, 对比两种不同热处理态的组织和 …

Metal matrix composites (MMCs) are an important class of materials replacing monolithic
alloys in applications where high specific strength and temperature and wear resistance are …