Y Ding, C Wen, P Hodgson, Y Li - Journal of materials chemistry B, 2014 - pubs.rsc.org
Magnesium (Mg) based alloys have been extensively considered for their use as biodegradable implant materials. However, controlling their corrosion rate in the …
The effect of applying 1, 5 and 10 turns of high pressure torsion (HPT) as a severe plastic deformation technique on the microstructural evolution, hardness, tensile and shear strength …
The aim of this study was to investigate the effect of adding 1, 2 and 4% wt of cerium on the microstructure, mechanical and corrosion properties of high pressure die casting (HPDC) …
F Qi, X Zhang, G Wu, W Liu, X He, W Ding - Materials Science and …, 2021 - Elsevier
This work was primarily aimed at evaluating the effect of heat treatment on the microstructure, high cycle fatigue behavior and mechanical properties of a novel sand-cast …
W Du, K Liu, K Ma, Z Wang, S Li - Journal of magnesium and alloys, 2018 - Elsevier
The effects of alloying elements of Ca/Sn on corrosion behaviors of the as-cast Mg–4Zn–0.2 Mn alloy were investigated by immersion tests and electrochemical methods. The results …
P Wang, E Guo, X Wang, H Kang, Z Chen, Z Cao… - Journal of Magnesium …, 2019 - Elsevier
The microstructure and tensile properties of the as-cast and as-rolled Mg–4.5 Sn–5Zn alloys by adding various Sc content were investigated. Improvement of the tensile properties in as …
The current investigation involved casting the Mg–2.2 Gd–2.2 Zn–0.2 Ca (wt%) alloy (GZX220) through permanent mold casting, followed by homogenization at 400° C for 24 h …
M Yang, H Li, C Duan, J Zhang - Journal of Alloys and Compounds, 2013 - Elsevier
In this paper, the effects of minor Ti addition (0.1–0.3 wt.%) on the as-cast microstructure and mechanical properties of Mg–3Sn–2Sr (wt.%) magnesium alloy are investigated. The results …
J Zhang, S Liu, Z Leng, X Liu, Z Niu, M Zhang… - Materials Science and …, 2012 - Elsevier
Mg–3.0 Al–2.2 La–0.3 Y–0.2 Mn (wt.%) alloy was prepared by high-pressure die-casting. The microstructure, thermal stability of intermetallic phases and mechanical properties were …