Abstract Microstructures of the Mg− 8Gd− xYb− 1.2 Zn− 0.5 Zr (x= 0, 1, 2, 3, and 4, in wt.%)
alloys prepared by gravity permanent mold casting were investigated. The results indicate …

Abstract Mg–Sn–Ca–Mn–xAl (x= 0, 1.5 wt%) alloys with ultra-fine recrystallized grains were
prepared by conventional extrusion (400° C, 0.5 mm/s). Effects of aluminum (Al) on …

Abstract In this study, Mg-Gd-Y-(Sm)-Zr (GW-(Sm)) alloys were subjected to compression
tests at both 293 and 77 K. The effect of Sm addition on the plastic deformation mechanism …

The effects of trace amounts of Ca on the microstructure and mechanical properties of as-
cast Mg− Sm− Gd− Zn− Zr alloy were systematically investigated mainly by means of …

The effects of minor Zn (0.2 at%, 0.4 at%, 0.6 at%) on the microstructures and mechanical
properties of Mg-1.4 Gd-1.2 Y-0.15 Zr (at%) alloys were systematically explored. Results …

The damping and mechanical properties of extruded Mg-Zn XY 1.33 X (X= 1, 2, 3 at%) alloys
were investigated in this experiment. The results shown that the alloy was mainly composed …

A new elevated-temperature high-strength Mg–4Er–2Y–3Zn–0.4 Mn (wt%) alloy was
developed by semi-continuous casting, solid solution treatment, and hot extrusion. W phase …

To clarify the controversy regarding the phase equilibria in the Mg-rich corner of the Mg-Zn-
Sm system, alloys annealed at 320° C and 400° C were employed to determine the phase …

In this article, the microstructure and mechanical properties of Mg–8Al–1Sm–1Zn alloy
prepared by multi‐pass conventional rolling and single‐pass liner rolling are investigated …

Wrought AZ (Mg–Al–Zn) series alloys have attracted lots of researches, due to low cost, high
strength and good formability. Few researches focus on creep characteristics of wrought AZ …