Nickel-based coatings with different content of zirconia were deposited on steel by short-
pulse laser melting of powder mixtures of pure components. High temperatures during laser …

Lap-welded joints between Ti–6Al–4V and Al–4Cu–1Mg were obtained using water-cooling-
bath friction stir welding at different FSW tool rotation rates. The increase in the tool rotation …

High-strength, lightweight alloys are highly desired in the aerospace, automotive and marine
industries. The optimization of such alloys is a multifaceted process, characterized by the …

Abstract Ti-40Al-10 V alloys with nearly lamellar structure (HIPed) and refined (B2+ γ)
microstructure (HT) were used to investigate the correlation between tribological behavior …

Using scanning and transmission electron microscopy, X-ray diffraction, profilometry,
indentation and friction tests we investigated the microstructure and phase composition …

In this paper, the interfacial adhesion work (W ad), tensile strength, and electronic states of
the Fe-amorphous Na2SiO3-Al2O3 and Fe-Al2O3 interfaces are well-investigated, utilizing …

Titanium and titanium alloys possess low density, high specific strength, and excellent
corrosion resistance, but are expensive and have low formability at room temperature …

The structure, microhardness, and tribological properties of coatings obtained in the process
of surfacing of powder mixtures by an electron beam ejected into an air atmosphere are …

Abstract (Ti–Al–Mn)/Ti metal–intermetallic layered material was prepared by SHS pressing.
It was found that the combustion product obtained in Ti–Al–Mn layer consists of hexagonal …

Изучены структура, микротвёрдость и триботехнические свойства покрытий,
полученных в процессе наплавки порошковых смесей электронным пучком …