Microstructure and corrosion behavior of the Mg-3Al-x Mn (x= 0, 0.12, 0.21, 0.36,
0.45)(hereafter in wt.%) alloys were experimentally investigated by electron probe …

The limited wide applicability of commercial Mg alloys is mainly attributed to the poor
corrosion resistance. Addition of alloying elements is the simplest and effective method to …

To investigate the effect of second phase on corrosion resistance of the Mg alloys, five as-
cast Mg-10Al-xMn alloys were designed based on thermodynamic calculations. The …

The effect of manganese on the corrosion properties of Mg–5Al alloy was investigated by
electrochemical techniques in 0.6 M NaCl solution and surface analyses. The …

The corrosion resistance of conventional and experimental Mg–3Al–1Zn-based alloys with
different Mn and Y content was comparatively investigated. After immersion for 72 h in a 0.6 …

In order to study the properties of Mg–Al–RE (AE) series alloys, the Mg–4Al–4RE–0.4 Mn
(RE= La, Ce/La mischmetal or Ce) alloys were developed. Their microstructures, tensile …

This study aims to investigate the correlation between the microstructure and corrosion
behaviour of AZ series alloys, using analytical scanning electron microscopy, X-ray …

The electrochemical corrosion behavior of Mg–5Al–0.4 Mn–xNd (x= 0, 1, 2 and 4wt.%)
alloys in 3.5% NaCl solution was investigated. The corrosion behavior of the alloys was …

Abstract In this study, Mg–8Li–2Al, Mg–8Li–2Al–1.5 Sn, Mg–8Li–2Al–1.5 Nd, and Mg–8Li–
2Al–1.5 Ca alloys were produced by the gravity die casting method. The effects of individual …

Adopting twin-roll casting (TRC) technique, lean Mg-1.2 Zn-0.3 Ca-0.3 Al-xMn (x= 0.25, 0.38,
0.5 wt%) alloys with different Al/Mn ratio were prepared. The stoichiometric ratio of Al 8 Mn 5 …