A previous paper (Mishra et al., 2008 [1]) showed that the ductility of extruded Mg–0.2% Ce
alloy is higher than that of magnesium and other conventional magnesium alloys. However …

Abstract Unalloyed Mg and Mg-0.2% Ce alloy were extruded as solid rounds at 400° C in a
500 ton vertical extrusion press at 10 mm/sec. Tensile tests revealed a significant increase in …

Two binary Mg–Y alloys and pure magnesium were prepared by extrusion. The effect of
yttrium on mechanical properties was investigated in comparison between the pure …

A novel extrusion− shearing (ES) composite process was designed to fabricate fine-grained,
high strength and tough magnesium alloy. The structural parameters of an ES die were …

Abstract A low-alloyed Mg-1.2 Zn-0.1 Ca (wt.%) alloy was extruded at low temperatures. The
alloy extruded at 150° C exhibits a yield strength (YS) of 374 MPa and an elongation of …

The microstructure and mechanical properties of extruded Mg–1.0 Zn–0.5 Ca alloys were
studied. Observation of the microstructure indicates that the addition of Ca tends to weaken …

Abstract Three dilute Mg-Zn-Ca-Mn alloys were successfully extruded at 24 m/min and the
alloy with lowest Zn content (0.21 wt%) can even be extruded at 60 m/min without any …

High strength–ductility synergy is difficult to achieve in Mg alloys. Although high strength has
been achieved through considerable alloying addition and low-temperature extrusion, these …

Mg and its alloys are the lightest structural metals available and are extremely attractive for
applications as lightweight components, particularly in the automobile, electronic, and …

A high-strength Mg-Gd-Zn-Zr alloy developed by a novel extrusion method called differential-
thermal extrusion (DTE) was detailed characterized, to reveal the effects of the DTE on …