Coarse eutectic phases generally exist in cast alloys and have dramatic effects on
mechanical properties and corrosion behaviors. Therefore, it would be convenient and …

Here we report a novel Mg-4.5 Al-1.5 Sn-0.5 Ca (wt%) alloy with high mechanical properties
produced via sub-rapid solidification (SRS) and controlled rolling. In virtue of SRS combined …

In this study, we successfully prepared a Mg-6Zn-0.2 Ca alloy by utilizing sub-rapid
solidification (SRS) combined with hard-plate rolling (HPR), whose elongation-to-failure …

Achieving high strength-ductility synergy is a great challenge in low-alloyed Mg alloys. In
this work, a new Mg–1.0 Zn–0.45 Ca–0.35 Sn–0.2 Mn (wt.%, ZXTM1000) alloy was …

Simultaneously improving the yield strength (YS) and formability at room temperature of
magnesium (Mg) alloys is one of the key issues to broaden the application further. In this …

The mechanical property and in particular the corrosion behavior of an Mg–Al–Mn–Ca alloy
produced by spinning water atomization process (SWAP) were investigated and compared …

The aim of this study is to investigate the effect of minor cerium (Ce) on the microstructure,
mechanical properties, and corrosion behavior of rolled Mg-1.5 Sn-0.5 Ca alloy. The results …

The coarse segregative eutectic phases, emerged in the twin roll casting (TRC) process of
Mg strips, which cannot be resolved solely by controlling the processing variables or post …

High-temperature solid-solution is indispensable for bake-hardenable dilute Mg alloys,
which generally induces grain coarsening. Herein, we report extraordinary thermal stability …

The control of precipitation density has always been a difficult issue in the application of
precipitation strengthening mechanism. Here we reported the precipitation of Mg 2 Ca in a …