Based on the in-situ synthesis process, this study proposes a novel process that introduces
lithium salt-modified La 2 O 3p as a precursor into Mg–Li–Al–Zn (LAZ) alloy melt, achieving …

Here, the low-cost submicron La 2 O 3 particle modified by lithium salts as a precursor was
added to Mg–5Li–3Al–2Zn (LAZ532) alloy melt to form in-situ plenty of submicron Al 3 La …

In this study, LAZ532 alloy reinforced with Al 3 La phase in-situ precipitated by adding La 2
O 3 particle was fabricated by melting casting. The hot tensile deformation behaviour of the …

The multi-pass caliber rolling was applied to in-situ AlN/AZ91 composite rods, and the yield
strength of 295.3 MPa, ultimate tensile strength of 384.7 MPa, fracture elongation of 12.3 …

Abstract Although Mg-Li alloys have been recognized as super-light structural alloys which
have considerable ductility, weak strength and low corrosion resistance have limited their …

In-situ synthesized Al matrix composites (AMCs) have drawn lots of interest recently relying
on the designability of reinforcement configurations and promising mechanical properties. In …

The strength of conventional AZ91-based composites can be usually improved by the
extrusion process, however the inadequate ductility is often induced, which limits the …

To improve the strength of magnesium (Mg)-lithium (Li) alloy without sacrificing plasticity, Mg-
7.3 Li-4Al-3Ca alloy is designed and subsequently rolled at 350° C. The microstructure …

Microstructural evolution and mechanical properties of ultra-lightweight Mg-14 wt% Li-1wt.%
Al/Al-2wt.% Li composite produced by accumulative roll bonding (ARB) at ambient …

In the present study, microstructure and mechanical properties of casting Al-3Li-2Mg-1Zn-
0.1 Zr alloys modified by Sc additions have been investigated. As-aged Al-3Li-2Mg-1Zn-0.2 …